Vol. 32 No. 8(3)
Special Issue on Advances in Shape Memory Materials
Guest Editor: Ryosuke Matsui (Aichi Institute of Technology) and Hiroyuki Miki (Tohoku University)
The stress–strain curves of as-received shape memory alloys (SMAs), which are often used as sensors or/and actuators, vary among cyclic loadings. This phenomenon is caused by an irreversible p ... Read More
A tape-shaped Ti–Ni shape memory alloy (SMA) element, which demonstrates superelastic behavior, shows negative stiffness during post-buckling deformation. This characteristic is applied to a p ... Read More
The fatigue property of TiNi shape memory alloy (SMA) is one of the important issues for its use as a sensor element. In this study, the fatigue life of TiNi SMA was improved by ultrasonic shot ... Read More
The corrosion fatigue strength of a TiNi shape memory alloy (SMA) is crucial for ensuring safety when the material is used as a sensor or actuator element in a severely corrosive environment, suc ... Read More
As a powder metallurgy technique, the compression shearing method at room temperature (COSME-RT) is used for making metamagnetic shape memory alloy (MSMA) thin plates. COSME-RT is a method for c ... Read More
S&M2303Research Paper of Special Issue |
|
|
|
S&M2303 Constitutive Modeling of Shape Memory Alloy Including Martensite-transformation-induced Plasticity Tadashige Ikeda pp. 2825-2839 https://doi.org/10.18494/SAM.2020.2887 Published on August 31, 2020 PDF (open access) |
S&M2304Research Paper of Special Issue |
|
|
|
S&M2304 Finite Element Method Analysis of Effect of Thickness of Tape-shaped Ti–Ni Shape Memory Alloy on Post-buckling Behavior Takumi Ishii, Hiroki Cho, Atsushi Urakawa, and Takumi Sasaki pp. 2841-2849 https://doi.org/10.18494/SAM.2020.2886 Published on August 31, 2020 PDF (open access) |
S&M2305Research Paper of Special Issue |
|
|
|
S&M2305 Enhancement of Fatigue Properties in Sensor Element by Surface Modification Kohei Takeda pp. 2851-2858 https://doi.org/10.18494/SAM.2020.2893 Published on August 31, 2020 PDF (open access) |
S&M2306Research Paper of Special Issue |
|
|
|
S&M2306 Effect of Electrolytic Polishing on Corrosion Fatigue Strength of TiNi Shape Memory Alloy Ryosuke Matsui and Masato Okumura pp. 2859-2866 https://doi.org/10.18494/SAM.2020.2865 Published on August 31, 2020 PDF (open access) |
S&M2307Research Paper of Special Issue |
|
|
|
S&M2307 Metamagnetic Shape Memory Alloy Thin Plates Consolidated by Compression Shearing Method at Room Temperature for Thermal Energy Harvesting Device Hiroyuki Miki, Eijiro Abe, Sho Takeda, Makoto Ohtsuka, and Manfred Kohl pp. 2867-2875 https://doi.org/10.18494/SAM.2020.2938 Published on August 31, 2020 PDF (open access) |
Cover of this Issue |
 |